Tools
Parts
-
-
Any brand bearing press will work as long as the correct size bearing drifts are used. DO NOT HAMMER OUT BEARINGS , as this can lead to a de-bonded hub shell.
-
To skip to bearing installation, proceed to step 4.
-
Begin by removing the axle from the hub by following one of these guides:
-
-
-
-
-
Slide the bearing removal drift onto the threaded axle of the bearing press tool. Then slide the tool through the disc side of the hub.
-
Place the bearing removal cup on the non-disc side. This cup should be larger in diameter than the outer race of the bearing. Thread the remaining handle onto the bearing press tool.
-
Make sure the bearing removal drift and bearing removal cup are centered.
-
Tighten the tool handles to press the axle reducer and non-disc side bearing out of the hub shell.
-
The axle reducer will still be attached to the bearing. The bearing can be pulled off the reducer with firm hand pressure.
-
-
-
Slide the bearing removal drift and axle reducer onto the bearing press tool.
-
Place the bearing removal cup on the disc side of the hub. This cup should be larger in diameter than the outer bearing race.
-
Tighten the tool handles to press the axle reducer and the disc-side bearing out of the hub shell. The axle reducer will still be attached to the bearing. The bearing can be pulled off the reducer with firm hand pressure.
-
-
-
To install new bearings, begin by gently centering the disc side bearing onto the hub shell.
-
Slide the bearing press drift onto the bearing press tool. Press the remaining bearing on the axle reducer, and then slide the reducer onto the bearing press tool.
-
Be sure to center drifts to avoid damage to the bearing and/or uneven installation.
-
Tighten the tool to press both bearings into the hub shell, capturing the axle reducer between the bearings.
-
Install the axle and driver.
-
-
-
Thanks for reading, now get out there and ride!
-
