Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Chris Costello

Edit approved by Chris Costello

Before
After
Unchanged

Step Lines

[title] Installing the ring
[* black] Thread on lockring with spacers in correct location for chainring offset and rear hub spacing
[* icon_caution] Tightenblack] Tighten lockring to 30Nm (Snug + 90 degrees)
[* icon_caution] If setting up a configuration where the lockring is tightening against a spacer, ensure that the spacers are sitting fully in the grooves of the mounting location so the lockring is fully compressing the system.
[* icon_caution] Tightenblack] Tighten lockring to 30Nm (Snug + 90 degrees)
[* icon_caution] If setting up a configuration where the lockring is tightening against a spacer, ensure that the spacers are sitting fully in the grooves of the mounting location so the lockring is fully compressing the system.