Changes to Step #1

Edit by The Hive - Jeremy

Edit approved by The Hive - Jeremy

Before
After
Unchanged

Step Lines

-[* black] If needed, remove the set screw to access and remove the spoke
-[* icon_note] You may need to clamp the cam in the soft jaws to loosen the set screw. Be careful not to mar the cam
-[* black] Turn the set screw counter-clockwise to loosen
-[* black] Slide the spoke out of the cam
-[* black] Ready to re-assemble? Then go here
+[* black] We'll start re-assembly from inside the pillar, want to know how to take the post apart go [guide|83|here]
+[* icon_note] Slide the spoke into the cam. The 138mm spoke is for 125mm posts and the 210mm spoke if for 150mm posts.
+[* black] Apply a small amount of medium strength threadlocker to the threads of the set screw
+[* black] Turn the set screw clockwise to tighten. Tighten to 3 N*m
+[* icon_note] You may need to clamp the cam in the soft jaws to tighten the set screw. Be careful not to mar the cam.

Image 1

Old Version

New Version

Image 3

Old Version

New Version