Changes to Step #6
Edit by The Hive - Jeremy —
Edit approved by The Hive - Jeremy
- Before
- After
- Unchanged
Step Lines
[* black] Install the cap, be sure to line the ball up with the hole in the cap | |
- | [* black] Put a small amount of threadlocker on each screw and tighten with a |
+ | [* black] Put a small amount of threadlocker on each screw and tighten with a T15 Torx to 3N*m |
[* black] Replace the 4 brass keys as needed | |
[* icon_note] The brass keys will wear over time and may be responsible for rotational play in the post. They should be inspected for wear and replaced as needed. |