Changes to Step #6
Edit by The Hive - Jeremy —
Edit approved by The Hive - Jeremy
- Before
- After
- Unchanged
Step Lines
- | [* black] If needed, remove the brass post keys with a pick |
---|---|
- | [* black] The bushing at the bottom of the pillar can be replaced by removing the four T20 Torx screws at the bottom of the post then removing the cap and sliding the bushing off |
+ | [* black] Install the cap, be sure to line the ball up with the hole in the cap |
+ | [* black] Put a small amount of threadlocker on each screw and tighten with a T20 Torx to 3N*m |
+ | [* black] Replace the 4 brass keys as needed |
+ | [* icon_note] The brass keys will wear over time and may be responsible for rotational play in the post. They should be inspected for wear and replaced as needed. |
Image 1
Old Version
New Version
Image 3
Old Version
New Version