Changes to Step #9
Edit by The Hive - Jeremy —
Edit approved by The Hive - Jeremy
- Before
- After
- Unchanged
Step Lines
| - | [* black] Now we will remove the pillar assembly from the inner tube of the seat post |
|---|---|
| - | [* black] Using your T25 of another tool that fits, actuate the post just as a cable would if the post were installed |
| - | [* red] While pulling the cable tower down to release the locking mechanism, carefully slide the pillar out of the inner tube |
| - | [* yellow] Be careful here as the balls that lock the post may fall out once released. To prevent this, you can wrap the assembly in a rag before removal to contain the balls. |
| + | [* black] Using your T25 or another tool that fits, actuate the post just as a cable would if the post were installed by pulling on the cable tower |
| + | [* red] While pulling the cable tower down to release the locking mechanism, carefully slide the pillar in to the inner tube |
| + | [* yellow] Once the balls are inside the inner tube, release the cable tower and continue sliding the pillar into the inner tube until you hear them click into the first position |
Image 3
Old Version
New Version