Changes to Step #13
Edit by Cory Sullivan —
Edit approved by Cory Sullivan
- Before
- After
- Unchanged
Step Lines
| [* black] Lightly grease each end of the spring and install the spring in to the post | |
| [* icon_note] The spring is not directional, so either side can go up or down | |
| [* icon_note] It is recommended to put the seatpost in the vise and soft jaws for this step | |
| [* icon_caution] The spring is under preload and will eject with force if not supported while installing. Use caution! | |
| - | [* black] Next, |
| + | [* black] Next, apply a medium strength thread locker (blue loc-tite) to the threads and install the spring cap by compressing the spring while turning the cap clockwise |
| [* black] Tighten the spring cap to snug |