Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by The Hive - Jeremy

Edit approved by The Hive - Jeremy

Before
After
Unchanged

Step Lines

-[* black] Moving to the head of the post, insert the head of the post into the soft jaws of the vise
-[* black] Using an M10 hex wrench break the screw free by turning counter-clockwise and loosen it slightly, but do not remove
-[* icon_caution] The main spring is located under this screw, so caution must me used when removing the screw
+[* black] To tighten properly, you insert the head of the post into the soft jaws of the vise
+[* black] Using an M10 hex wrench tighten to 20N*m
+[* icon_caution] The main spring is located under this screw, so caution must me used when removing or tightening the screw
[* icon_caution] The head, and only the head of the post must be supported while removing this screw. Supporting the main tube or shaft of the post while turning this screw may result in damage/binding of the seatpost keys