Changes to Step #16
Edit by The Hive - Jeremy —
Edit approved by The Hive - Jeremy
- Before
- After
- Unchanged
Step Lines
- | [* black] Remove the cable tower at the bottom of the post using a 15mm wrench. Turn counter-clockwise to remove |
---|---|
+ | [* black] Put a small amount of threadlocker on the threads of the cable tower |
+ | [* black] Slide the spacer/washer over the threads |
+ | [* icon_note] In some cases the spacer/washer may be pressed on to the cable tower |
+ | [* black] Tighten the cable tower to 6N*m |
[* icon_note] If needed, clamp the seatpost in softjaws or use a strap wench to hold the post |
Image 1
Old Version
New Version
Image 3
Old Version
New Version