Changes to Step #3
Edit by The Hive - Jeremy —
Edit approved by The Hive - Jeremy
- Deleted
- Added
- Unchanged
Step Lines
[* black] Install the guide on the bike |
[* black] [* black] Remove the drive side BB cup and slide the guide and spacer over the BB |
[* black] [* black] Remove the drive side BB cup and slide the guide and spacer over the BB |
[* icon_note] Clean any grease off of the mounting face of the guide and BB, this will help keep the guide from rotating on impact |
[* black] Snug down the BB |
[* black] [* black] sight down the back of the bike and make sure the chainrings are centered over the roller, adjust the 0.5mm spacer as needed to center the rings over the roller |
[* black] [* black] sight down the back of the bike and make sure the chainrings are centered over the roller, adjust the 0.5mm spacer as needed to center the rings over the roller |
Image 2
Old Version
New Version