Site Navigation

Your Account

Choose Language

Remove the axle and freehub body using this guide: Generation 2 axle - TRSr/TRS+/LG1+ rear hub axle install and removal You should just have the hub shell, bearing spacer and bearings left to remove

Add Comment

Using the e*13 bearing service tool, insert the bearing removal tool in though the drive side bearing Each bearing has two cut outs on the back side, this is where the removal tool will sit Sight down through the hub to properly align the bearing removal tool, it can help to use a flashlight
  • Using the e*13 bearing service tool, insert the bearing removal tool in though the drive side bearing

  • Each bearing has two cut outs on the back side, this is where the removal tool will sit

  • Sight down through the hub to properly align the bearing removal tool, it can help to use a flashlight

Add Comment

With the wings of the bearing removal tool set in the slots behind the bearing, insert the press rod, threaded rod and handle through the hub On the opposite side, place the bearing removal cup and other tool handle Make sure all pieces are aligned and tighten the handles. This will press the bearing out of the hub shell in to the bearing removal cup
  • With the wings of the bearing removal tool set in the slots behind the bearing, insert the press rod, threaded rod and handle through the hub

  • On the opposite side, place the bearing removal cup and other tool handle

  • Make sure all pieces are aligned and tighten the handles. This will press the bearing out of the hub shell in to the bearing removal cup

Add Comment

Repeat the previous steps with the other bearing
  • Repeat the previous steps with the other bearing

  • Angular contact bearings are only supported on one side by the bearing race, as a result they must be pressed in and out using only the outer race

Add Comment

Now let's reinstall the bearings
  • Now let's reinstall the bearings

  • Angular contact bearings must be installed in the correct direction. One side of the bearing should have a thicker inner race than the other, this side will face out from the center of the hub

  • You can also use the bearing seal cover color to determine the direction, the green seal should face out, the black seal should face in towards the center of the hub

Add Comment

To install bearings, start by installing the disc side bearing Insert the black bearing centering tool into the bearing tool Slide the bearing over the bearing press tool
  • To install bearings, start by installing the disc side bearing

  • Insert the black bearing centering tool into the bearing tool

  • Slide the bearing over the bearing press tool

  • Slide the other bearing press tool into the drive side bearing bore

Add Comment

Tighten the tool handles to press the bearing in
  • Tighten the tool handles to press the bearing in

  • Be sure the bearing presses in straight

Add Comment

Repeat the previous steps to press in the drive side bearing Be sure to install the drive side bearing using the bearing centering tool Be sure to install the drive side bearing using the bearing centering tool
  • Repeat the previous steps to press in the drive side bearing

  • Be sure to install the drive side bearing using the bearing centering tool

Add Comment

Lightly grease and slide the bearing spacer back between the bearings from the drive side

Add Comment

Conclusion

Thanks for reading, now get out there and ride!

Dozuki System

Member since: 09/24/2009

12 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 9

Past 30 Days: 64

All Time: 2,146